The green dots at both ends of the cable indicate the correct cable type. Use the local laptop connect to the switch console and configure the laptop with the right parameters for console access to the Cisco 2960 Catalyst switch 2. However I am not able to pass this part: b. Please check the name and try again'. You can find the default gateway either in the addressing table if given or in the network topology. Be sure to order them correctly and remember which command mode you are in.
. Hint: To ensure that the instructions always remain visible during an activity, click the Top check box in the lower left-hand corner of this instruction window. As you can see in image below that system is connected. I will walk you through all of the commands to accomplish each objective of this lab. Had to walk away from it a week or so ago so I don't recall what I had tried previously, but some combo worked when I connected them using a cross-over which I know is wrong but never worked with a straight-through. Only a little over an hour long, this self-paced course is for beginners with no prior networking knowledge.
Select the device option that is required. Subnet Mask will appear automatically. You need a Cisco Network Academy account in order to download and use Cisco Packet Tracer. In the first drop down box choose Coaxial and in the second drop down box choose Ethernet then click the Add button to add these as the From Port and To Port as shown in the figure. This article has also been viewed 43,385 times. This will save you lots off typing although it is not always necessary to have each word in a command completely spelled out. To create this article, volunteer authors worked to edit and improve it over time.
Your browser should prompt you to download Packet Tracer. This is the address of the other computer. Routing protocols can also be traced. We also share information about your use of our site with our social media, advertising and analytics partners. We are now prepared to enter the commands to complete the lab.
You should see the following page. In this article, I will show you how to install and use Cisco Packet Tracer on Ubuntu 18. Packet Tracer is a protocol simulator developed by Dennis Frezzo and his team at Cisco Systems. For this lab we will keep it simple by using End Devices, Switches, Hubs, and Connections. The workspace is where you place and connect network devices.
This is the address of the other computer. Go to the Desktop tab. Now click on Network Devices icon and then click on Switches icon as marked in the screenshot below. Press y and then press to continue. After configuring this, you should be able to 1. Your completion percentage should be 100 percent.